Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2
Wiring
- You must have the possibility to switch off indivi-
dually each motor.
- Attach cables to prevent any contact with moving parts.
- If the motor is used outdoors and if the power supply
cable is of the H05-VVF type, then run the cable in a
UV-resistant conduit, e.g. trunking.
3
Compatible transmitters
1 : 1/5 channels Wall Hz transmitter/ Memory Hz
2 : 1/5 channels Mobile Hz transmitter
3 : Color Multi/Timer Easy/Timer Multi transmitters
4 : Hz Sun sensor
Location of the PROG key on Hz transmitters:
Do not position the transmitter near metal in order to avoid range
losses.
4
Memorizing the automatic settings
If the installation includes several motors, only one motor is to be powered during this programming procedure. It will elimi-
nate interferences with the other motor during the procedure.
4.1- Learning mode:
- Switch the motor ON.
- Simultaneously press the "UP" and "DOWN" keys of a Hz transmitter.
The motor will run for 0,5 second in one direction, then in the other.
The transmitter now controls the motor in unstable mode, move to stage 4.2
4.2- Checking the rotation direction:
Press the "UP' key of the transmitter:
a
>>
a- If the motorized tube runs in the UP direction, move to next stage (4.3).
b- If the motorized tube runs in the DOWN direction, reverse the rotation direction by pressing the "Stop" key for at least 3
seconds.
The motor will run for 0,5 second in one direction, then in the other direction. Move to the stage 4.3.
4.3- Memorizing the automatic settings.
A
1
OK
4.3
>>
>>
b
1- Simultaneously press the "UP" and "DOWN" keys of a Hz transmitter.
2
The motor will run for 0,5 second in one direction and then in the other.
2s
2- Press the "Stop" key for 2 s. The motor will run for 0,5 second in one
direction and then in the other.
The operation is completed. Go to stage §5.
N
L
PE
(12 transmitters (channels) max. for one motor.)
1
>>
>>
T5 AUTO SHORT Hz
2
3
4
>>
ON
OK
>>
Blue
Brown
Green / yellow
4.3
>>
2 / 4
Tabla de contenido
