Simu T5 AUTO SHORT Hz Manual Del Usuario página 5

These instructions apply to all T5 AUTO SHORT Hz drive, the different versions of which are available in the current catalogue.
Field of application: T5 AUTO SHORT Hz drive are designed to drive all types of roller shutters equipped with stop blocks and rigid links. The instal-
ler, who must be a motorisation and home automation professional, must ensure that the drive product is installed in accordance with the standards
in force in the country in which it is installed such as EN 13659 relating to roller shutters.
Liability: Before installing and using the drive, please read operating and installation guide carefully. Please read these instructions carefully
before installing and using the drive. In addition to following the instructions given in this guide, the instructions detailed in the attached Safety ins-
tructions document must also be observed. The drive must be installed by a motorisation and home automation professional, according to instruc-
tions from Simu and the regulations applicable in the country in which it is commissioned. It is prohibited to use the drive outside the field of application
described above. Such use, and any failure to comply with the instructions given in this guide and in the attached Safety instructions document,
absolves Simu of any liability and invalidates the warranty. The installer must inform its customers of the operating and maintenance conditions for the
drive and must provide them with the instructions for use and maintenance, and the attached Safety instructions document, after installing the drive.
Any After-Sales Service operation on the drive must be performed by a motorisation and home automation professional. If in doubt when installing
the drive, or to obtain additional information, contact a Simu adviser or go to the website www.simu.com.
Installation
1
Instructions which must be followed by the drive and home automation professional installing the drive:
- Methods of wiring are given by national standards or IEC60364 standard.
- Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve.
- The cable for the motor can be removed. If it is damaged, replace by the same. The cable may only be connected to the
motor by qualified personnel. The connector is to be assembled without damaging the contacts. The continuity of the earth
connection must be ensured.
Recommendations: Keep a minimum distance of 20 cm between two T5 AUTO SHORT Hz motors. Keep a minimum
distance of 30 cm between T5 AUTO SHORT Hz motors and Hz transmitters. A radio appliance using the same frequency
(433,42MHz) may deteriorate our product's performance (ex. : hi-fi radio headphones). To receive information regarding the
compatibility of the motor and the roller shutter or/and accessories, contact the roller shutter manufacturer or SIMU.
Drilling of the tube:
Mounting:
T5 AUTO SHORT Hz
(230V~50Hz)
T5 AUTO SHORT Hz 06/17
55
45 24
120
* 35 Nm max.
V.A.R
V.A.S
EASYLINK
OCOTEASY
MANDATORY
2
1
364
22,8
IP44
48*
4
387
3
EN- ORIGINAL INSTRUCTIONS
5057768E
S.A.S. au capital de 5 000 000 € - Z.I. Les Giranaux
BP71 - 70103 Arc-Les-Gray CEDEX
RCS GRAY B 425 650 090 - SIRET 425 650 090 00011
n° T.V.A CEE FR 87 425 650 090
351
1
3
2
4
i
-20°C / +60°C
4 x Ø5 / 90°
47
min.
STEEL
2
1
1 / 4