Dolmar MB-CS Manual De Instrucciones Original página 7

3. Remove 2 caps from both ends of the pipe.
1
► 1 . Pipe 2. Cap
NOTICE:
Do not dispose of the caps since the
cap is necessary for storing the attachment.
4. Attach the protector and the sleeve to the pipe.
4
► 1 . Pin 2. Pipe 3. Protector 4. Sleeve
NOTICE:
Be sure to insert the end of the pipe
without the pin into the protector and the sleeve.
5.
pipe are facing up, and then insert the pipe into the gear
case.
2
► 1 . Gear case 2. Pipe 3. Pin
NOTICE:
pin on the pipe are facing up, and the protector is
1
attached in the direction shown in the figure.
2
► 1 . Gear case 2. Protector 3. Pin
6.
the gear case by rotating the pipe.
3
► 1 . Hole 2. Pipe
7 ENGLISH
Make sure that the gear case and the pin on the
1
Make sure that the gear case and the
1 2
Align the screw hole on the pipe with the hole on
1
2
3
3
2