Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
2. Operation
Connect the power cable to a 13 ampere supply that is located in a safe, dry area.
1. The switch on the heater head is used to control the three heats setting. (I) for 650 W --- (II) for
1300 W --- (I & II) for 2000 W. The 0 position is off.
2. Although the patio heater is shower proof, do not use when raining or in wet conditions.
3. Always disconnect the power cable from the electrical supply, when the patio heater is not in use.
3. Care and Maintenance
1.
When disconnected from the electrical supply, clean the outside of the patio heater with a damp cloth.
Never use corrosive or solvent cleaners or immerse in water.
2.
Any maintenance or repairs including replacing the electric halogen heater tube should only be carried
out by a qualified electrician or by a recommended service center.
4. Technical Specification
1.
Power supply 230 V ~50 Hz
2.
Wattage max 2000 W
3.
Net weight 3.60 kg: Gross weight: 4.60 kg
4.
Insulation class I.
5. Caution!
Only use the electric halogen patio heater on a firm vertical pole where all the feet on the pole base are in
contact with the floor.
(Should the heater be tilted or fall over the auto cut off switch will activate)
1.
Do not use the electric halogen patio heater near bath tubs, wash areas or swimming pools.
2.
Do not use in unventilated areas.
3.
Do not use where gas, petrol, paint or other inflammable goods are stored.
4.
Do not push any items through, obstruct or cover the grill of the heater head.
5.
The heater must not be located immediately below a socket-outlet.
6.
Do not move when connected to an electrical supply and always wait for the patio heater to cool down
before storing away.
7.
Do not touch the heater head when in use.
8.
Do not leave turned on and unattended especially when children and or animals are in the vicinity.
9.
The unit must be placed with the clearance of 180 cm to the floor and 30 cm to the roof / parasol cloth.
10. The unit must be correctly installed according to the instructions. Make sure the heater is fixed at a height
of at least 1.8 m above the floor.
11. The unit must be securely placed on a pole which is vertically to the flat surface.
10
Capítulos
Tabla de contenido
