Tabla de contenido
Idiomas disponibles
Idiomas disponibles
• Place the nozzle of the tool
against the surface and press
gently on the trigger to extrude
glue. Place the second element
in contact with the glue, if need
be adjust it and press parts
together for an average of 10
seconds.
• Use only glue sticks
recommended.
• Never pull/remove a glue stick
from the tool once is has been
fed into the tool. The resultant
molten glue could create
irreparable damage to the tool.
• Once finished, put the switch (3)
on "0" (off).
• When the battery is decharged,
the green LED light (4) will go
out.
OPERATING INSTRUCTIONS
OF CHARGER:
• Do not use the tool whilst.
Ensure the tool is switched in
the "off" position "0", or remove
the battery out off the tool.
• Connect the charging point (9)
of the charger into the socket (6)
off the battery.
• Connect the charger (10) to the
mains. â the LED (11) on the
charger will turn red during the
charge.
SICHERHEITSHINWEISE:
Achtung! Bitte lesen Sie die
Hinweise vor Inbetriebnahme
der Klebepistole sorgfältig
6
• When the battery is full charged,
the LED (11) off the charger turn
green.
• Disconnect the plug (9) out off
the socket (6) and unplug the
charger (10) from the mains.
• During the process of charging,
the charger can become warm:
this is normal.
PROTECTING THE
ENVIRONMENT:
Separate Collection. Do not
dispose of power tools into
household waste!
According to the European
Directive 2012/19/EU on
waste electrical and electronic
equipment
• Should you find one day that
your tool needs replacement, or
if it is of no further use to you, do
not dispose of it with household
waste. Bring it to a separate
collection centre for recycling.
• Battery: the batteries are
recyclables.
The battery can be recharged
many times. At the end of their
useful life, run the battery down
completely, then remove it from
the tool, and take it to a local
recycling station.
durch. Bei Nichteinhaltung der
Sicherheitshinweise besteht
Stromschlag-, Feuer- und
Verletzungsgefahr. Bewahren Sie
Tabla de contenido
