Operating Instructions - Original; Use Of The Tool - Rapid EG330 Manual De Instrucciones - Traducción Del Original

EG330

Operating instructions - Original

TECHNICAL SPECIFICATIONS:
Weight 0,500 kg
Voltage / Frequency 220 - 240 V / 50Hz with Ground
connection
Power 380 W at Start-up
280 W in use
Insulation type Class I
Glue temperature, t° regulation type 180°C (360°F) and 205°C (400°F),
Regulated by 2 thermostats. Temperature
selection done by external switch.
Glue sticks specifi cations Original RapidTM Ø 12 mm – ½ ''
The manufacturer reserves the
right to change specifi cations wit-
hout notice.
SAFETY INSTRUCTIONS:
READ CAREFULLY BEFORE
USING THE GLUE GUN – HOT
MELT APPLICATOR
• HOT SURFACES: The glue
and the nozzle of the tool can
reach temperature up to 200°C
(400°F). Avoid all skin contact.
If burnt, plunge the burn under
cold water. Never attempt to
remove large lump of glue from
burnt skin without medical
assistance.
• DO NOT use the tool in damp
or wet conditions or expose it to
water projections.
• If the power supply cable is
damaged, UNPLUG the tool by
pulling the plug out of the wall
socket. Never pull the cord to
unplug the tool.
• NEVER put object in the tool
other than recommended Glue
stick specific diameter.
• NEVER take a Glue stick out
of the tool once it has been put
into the tool. Molten glue could
4
create irreparable damages to
the tool.
• Children should only use the tool
under supervision of an adult.
• ALWAYS unplug the tool prior
to proceed to maintenance or
cleaning.
• ALWAYS make sure that the
tool is connected to a 220-
240V / 50Hz wall socket with
ground connection. If need
be, an extended power cord in
perfect condition can be used.
• When unplugged, ALWAYS
make sure that the tool is at
room temperature prior to store
it.
• WARNING: This tool must be
placed on its stand when not in
use
• THIS APPLIANCE can be
used by children aged from 8
years and above and persons
with reduced physical, sensory
and mental capabilities or lack
of experience and knowledge
if they have been given
supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved. Children
shall not play with the appliance.
Cleaning and user maintenance
shall not be made by children
without supervision.

USE OF THE TOOL:

• Start-up : Plug the tool into
a 220 - 240V / 50Hz wall
socket with ground connection.
Working temperature is obtained