Install The Cutting Line; Remove The Trimmer Head - GreenWorks Pro Ultrapower X-Range 60 60TB16 Manual Del Operador

20
19
23
4. Put the spool cover with spool in the spool housing (23).
5. Push the tabs until the spool cover clicks into position..
10.4

INSTALL THE CUTTING LINE

Do not put more than 15 feet of cutting line in at a time.
1. Remove the remaining cutting line on the spool.
2. Line up the slot on the spool cap with the line exist hole
on the trimmer head.
3. Put the cutting line through the hole. Push the cutting line
until it exits the opposite hole.
21
NOTE
Spool cover
Slot
Line exist
hole
English
4. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
5. Turn the spool cap clock-wise to wind the cutting line
into the trimmer head. Keep approximately 5 in of cutting
line above out of each side of the trimmer head.
10.5

REMOVE THE TRIMMER HEAD

1. Put the metal rod (E) in the specified angle transmission
hole (D) to fix the trimmer head.
2. Remove the spool cover and the spool.
3. Loosen the nut (A) on the trimmer head clockwise with a
wrench.
11
EN