Tabla de contenido
Idiomas disponibles
Idiomas disponibles
GENERAL ELECTRICAL AND
SAFETY WARNINGS
• Do not cut the solar panel wire. Discontinue use if the
wire becomes frayed or broken.
• Do not immerse components in liquid.
• Do not use any other charging device other than the
single solar charging panel provided with this light. Do-
ing so may result in injury or damage to the light and
voids any warranty.
• Position the cord so that it is securely fastened and will
not result in a hazard (such as tripping).
THINGS TO REMEMBER
• Periodically clean the solar panel with a soft cloth and
warm water. Do not hose spray. Keep the collector clear
of snow and leaves. Make sure trees and other objects
do not block sunlight from the panel.
• If not to be used for several weeks, turn the unit OFF.
Store it with the panel connected and where the panel
can gather sunlight.
• Solar collection is only effective in direct sunlight. Every
hour the light is on requires a minimum of 16 hours of
sunlight charging. Solar panels collect less than 10%
of the sun's energy.
• Several days of use with overcast skies may discharge
the battery. If so, turn the power selection switch to the
OFF position and allow the sun to charge the battery
for 3 to 7 days.
STORAGE
If you wish to store your light indoors for more than two
or three days, follow these steps to prevent damage to
the battery:
1. Turn the power selection switch to the OFF position.
2. Keep the solar panel cord connected to the light and
store the light and solar panel where the solar panel
can receive some sunlight or room light each day.
The battery needs light to maintain a charge during
storage.
BATTERY REPLACEMENT
This solar light contains rechargeable batteries that
can be replaced if needed. Rechargeable batteries will
eventually lose their ability to hold a charge. To replace
the battery follow the steps below.
IMPORTANT: The rechargeable batteries must be
recycled or disposed of properly.
1. Loosen the screw from the bottom rear of the light
fixture. Release, but do not remove this screw.
2. Pull the bottom of the light fixture away from the
mounting plate, then remove the entire fixture from
the mounting plate.
3. Remove the battery cover and remove the old bat-
teries. Install four new 1.2V AA Ni-MH rechargeable
batteries into the battery compartment. Make sure the
polarity of the batteries is correct.
WARNING: If using this light while attached to the
solar panel, only use 1.2V AA Ni-MH rechargeable
batteries. Use of standard non-rechargeable AA
batteries while the light fixture is attached to the
solar panel can cause damage to the light fixture
and personal injury or property damage due to
fire.
4. Place the top rear of the light fixture over the wall
mounting plate, rotate downward and press into the
wall plate to ensure a weatherproof seal is obtained.
5. Fully tighten the screw at the bottom rear of the battery
case to secure the fixture to the wall plate.
1.2V AA Ni-MH Re-
chargeable Batteries
4
Wall
Mounting
Plate
Battery
Cover
206153-01
Tabla de contenido
