6
S
afety Information
WHEN USING
THE WASHING
WHEN NOT
IN USE
WARNING
Do not use a plug socket and wiring equipment for more than their rated
capacity.
Exceeding the limit may lead to electric shock, fire , break down, and/
or deformation of parts.
Do not mix chlorine bleach with ammonia or acids such as vinegar and/or
rust remover.
Mixing different chemicals can produce toxic gases which may cause death.
Do not wash or dry articles that have been cleaned in, washed in, soaked in,
or spotted with combustible or explosive substances (such as wax, oil, paint,
gasoline, dry-cleaning solvents, kerosene, etc). Do not add these substances
to the wash water.
Do not use or place these substances around your washer or dryer during
operation.
It may ignite or explode.
CAUTION
• Turn off water faucets to relieve pressure on hoses and valves and to minimize
leakage if a break or rupture should occur. Check the condition of the fill hoses;
they may need replacement after 5 years.
• When the air temperature is high and the water temperature is low,
condensation may occur and thus wet the floor.
• Wipe off dirt or dust on the contacts of the power plug.
Using unclean power plug may cause fire.
• Before discarding a washer, or removing it from service, remove the washer lid
to prevent children from hiding inside.
Children may be trapped and suffocated if the lid is left intact.
Do not attempt to repair or replace any part of this appliance unless specifically
recommended in this Owner' s Manual, or in published user-repair instructions
that you understand and have the skills to carry out.
Operating the machine with improperly replaced parts may be a cause
for fire or electric shock.
Do not tamper with controls.
It may lead to electric shock, fire , break down, deformation.
Do not yank the power cord in an attempt to disconnect the power plug.
Securely hold the power plug to unplug the machine.
Failure to observe these instructions may cause electric shock or fire
due to short-circuit.
When you are cleaning the washing machine, do not apply water directly to
any part of the washing machine.
It will cause short circuit and electric shock.
