32
C
leaning and Maintenance
Cold water washing
• If you always use Cold water, we recommend that a Warm or Hot wash be used at regular intervals e.g.
every 5th wash should be at least a Warm one.
When you have finished
• Turn off taps to prevent the chance of flooding should a hose burst.
• Always unplug the power cord after use.
When water supply into the tub is not clean or the filter is clogged with particles (such as sand), clean the
filter in the inlet valve occasionally.
(The figure of power cord and water tap may vary according to the country)
To Clean the Filter in the Inlet Valve
Close the tap before turning off
1
the power. Hot/Cold (Warm) and
then press the [START/PAUSE]
button to briefly start a wash in
order to completely remove all
water pressure from the hoses.
3
After removing the
water supply hose pull
out the filter.
Then use a brush to clean
the filter.
NOTE
• Before cleaning the filter, the impurities in the water supply hose should be removed.
To Clean the Lint Filter
1
Do NOT rotate this filter as it pivots out along the bottom edge.
NOTE
• If the lint filter is torn or damaged, purchase a new one from LG service center.
To Clean the Pump casting (for pump model)
Place a towel on the floor
1
under the drain pump
cap. Excess water may
flow out.
NOTE
• Check if water leaks after reassembling. (The Rubber ring is in the cap)
2
3
Turn the cap counter-
2
clockwise and pull
it out.
Cap
2
Turn off the power before
pulling out cord.
4
Replace the filter after
cleaning it.
4
5
Remove any foreign
3
objects and fluff inside
pump casing and from
the filter
Filter
6
Replace the cap. Insert the
4
filter along the guide ribs
inside the pump casing.
Filter must face the guide
ribs inside pump casing
and securely turn the cap
clockwise
Guide rib
Filter
Rev :01 (09T15)
