Engine Stop; Using The Machine - Garland BOLT 925 QG Manual De Instrucciones

Ocultar thumbs Ver también para BOLT 925 QG:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

Tighten, repair or replace everything you need to
before using the machine. Do not use any accessory
on this machine outside of those recommended by us
since its use could cause serious damage to the user,
the machine and people, animals and things close to
the machine.
NOTE: This machine has an oil sensor to prevent
the engine from starting with an oil level below the
recommended minimum. If the oil level is too low the
engine will not start.
6.5.2. PLACEMENT OF THE MACHINE
Make sure that you install the machine in a stable
position.
Connect a cable from the ground
generator grounding.
6.5.3. START
Follow the starting procedure depending on the state
of your engine.
6.5.3.1. STARTING THE MOTOR IN COLD
• Place the machine on a flat, stable surface to start it.
• Place the circuit breaker in alternating current (AC)
in the OFF position.
• Place the faucet of the fuel in the open position
(ON).
• Place the choke in closed air position
• Set the switch of the motor to the on position (ON).
• Hold the machine by casting so it doesn't move
from its position on the floor when pulling the
starter rope.
• Pull the starter rope until the engine starts.
• If the machine starts and doesn't stop gradually
changing the air level position
• Let the engine warm up for a few minutes before

using the machine.

6.5.3.2. STARTING THE MOTOR HOT
• Place the machine on a flat, stable surface to start.
• Place the circuit breaker in alternating current (AC)
in the OFF position.
• Place the fuel tap in the open position (ON).
• Place the choke in the normal working position
outlet of
(open position RUN).
• Set the switch of the motor in position (ON).
• Hold the machine by the handle so it doesn't move
from its position on the floor when pulling the
starter rope.
• Pull the starter rope until the engine starts.
• If after a few attempts the machine does not start
follow the steps in the engine starting.

6.5.4. ENGINE STOP

- Turn the engine switch with the ignition key off (0).
- Place the fuel tap in the closed position.
7. USING THE MACHINE
it is designed. The use of this machine for any other
use is dangerous and can cause harm to the user
and/or the machine.
(CHOKE).
37/120
Use this machine only for the purposes for which
Do not start the machine in a room or
enclosure. The exhaust gases, fumes from
English
(air open RUN).
Tabla de contenido
loading

Tabla de contenido