Modeling Flash; Exposure Compensation - Sigma EF-530 DG SUPER EO-ETTL II Instrucciones

FE LOCK
"FE" lock mode allows you to choose
1. Set the camera's exposure mode ("P", "Tv", "Av", "M" or "DEP").
2. Set the flash's mode to the E-TTL or the High Speed Sync.
3. Focus on the subject
4. Focus on the subject in the center AF frame of the viewfinder, and depress FE lock button.
◆ The flash unit will make a
correct exposure.
◆ The camera's viewfinder will display "FEL" for 0.5 sec and the correct exposure will be set.
◆ If the viewfinder shows
closer to the subject and repeat from step 3.
5. After composing the picture, press the shutter button.
This function may vary depending on camera model. For
◆
instructions of your camera manual.

MODELING FLASH

If useing the Modeling flash, you can check the lighting and shadow
(This function is limited
refer to the instruction manual of your camera)
When the camera is set to modeling flash, the Flash panel will display the

EXPOSURE COMPENSATION

You can use flash exposure compensation in combination with normal exposure
the background exposure
increments (or in 1/2 stop increments with some cameras).
◆ This mode cannot be used with EOS 620, 650, 700, 850 and 1000 cameras.
1. Press the SEL button and select
2. Press the + or -
compensation amount.
3. Press the SEL button until the display stops
4. Focus on the subject.
5. Check that the subject is within the flash range as displayed on the
EF 530 DG Super's LCD panel.
6. You can take the picture after confirming that the Ready Light of the
flash is illuminated.
◆ To cancel exposure compensation, please start from step 1 and choose + 0 on display.
FB (Flash Exposure Bracketing)
With FB, you can get bracketed flash shots of the
constant. The bracketed flash shots can be taken in the sequence of correct exposure, under exposure and
over exposure, up to ± 3 stops in 1/3EV increments (or 1/2EV increments with some cameras).
1. Press the SEL button
2. Press the + or - button to set the flash exposure bracketing
amount.
3. will be displayed after pressing the SEL button again.
4. Adjust the focusing.
5. Please check that the subject is within the flash range displayed on
the EF- 530 DG Super's LCD panel.
6. Check the mark is displayed in the virefinder and
7. If it is necessary, repeat steps 4 to 6.
◆ This function will be cancelled automatically after making the third exposure.
19
and lock the exposure before taking the picture.
pre-flash, then calculate and
mark, it means that power is not sufficient for correct exposure. Please get
to cameras which are compatible with modeling flash. For more details, please
level. Flash exposure compensation can be set to
.
button to set the desired flash exposure
until blinks.
memorize the
more details please refer to "FE lock"
blinking.
subject while
take the picture.
amount of light necessary for
effects before taking the picture.
symbol automatically.
compensation to
±3 stops in 1/3 stop
the ambient exposure level remains
the
control