BFC L 8 Instalación Y Mantenimiento página 18

This machine may only be used with foodstuffs. It cannot be used for liquids or any other kind of
product that could damage and pollute it.
This appliance isn't intended to be used in household and similar applications such as: staff kitchen
areas in shops, offices and other working environments; farm houses; by clients in hotels, motels and
other residential type environments; bed and breakfast type environments.The manufacturer cannot
be held responsible for damage to people or things caused by unsuitable, erroneous or irrational use.
This booklet is a guide to rapid and easy use and maintenance of coffee machines.
Please read these instructions carefully.
The company garantees that should any defect or problem occur, it will provide its support through
its Repair Service points.
Have your coffee machine inspected by qualified personnel at least once a year. This
constant care will make your machine safer and more efficient.
Our coffee machines have been designed and manufacured in complicance with all specifications that
distinguish traditional espresso coffee machines: noble materials such as copper and steel and reliable
components make alla machines made by the company safe, reliable and funciontal.
No liability can be accepted by the company for any damage to persons or things caused by non-com-
pliance with these instructions.
1) Remove the coffee machine from its parcking and check that it has not been damaged.
2) Place the appliance on a stable top, close to the mains sockets and water line connections.
The machine's uppermost surface must be at least 1,5 m off the ground.
Level the coffee machine by adjusting its feet. The machine must be installed in a horizontal position.
The inclination of the support surface must not be greater than 1°. To ensure normal operation, the
machine must be installed in places where the ambient temperature is between +5°C and +32°C and
humidity does not exceed 70%. Do not use water jets or install in places where water jets are used.
Check that the voltage of your mains supply corresponds to that indicated in the technical specifica-
tions.
4a. Equipment with 4 Liters Boiler, with internal tank
Before rotating the the switch knob to position 1, fill the rear water tank under the cup
shelf.
3) Remove the upper cover grid, take out the water tank (located inside the machine) and rinse it.
4) Fill the tank with approx. 4 litres clean water, put it back, connect the water softener and insert the
small silicone tubes. Close the upper cover grid on the machine.
5) Before start-up the fitter must make sure the machine has been properly connected to the electrical
and earthing systems involved and check the efficiency of protection from direct contact.
In Europe connect the approved cord H05VV-F 3G 1.5 mm with the Schuko plug to the electricity
supply. In USA-Canada connect the approved cord Type SJTO, rated 3x14 AWG, 300 V, 105°C with
the NEMA 5x15P plug to the electricity supply. IT IS STRICTLY FORBIDDEN TO USE THE
MACHINE WITHOUT EFFECTIVE SAFE EARTHING.
4b. Equipment with 4 Liters Boiler, with water supply connection
If your machine is to be connected to the mains water supply call a specialized techni-
cian.
10
2. PRECAUTIONARY MEASURES
3. INTRODUCTION
4. INSTALLATION