Troubleshooting - BGS technic 3382 Manual De Instrucciones

TROUBLESHOOTING

If the following table does not lead to the correction of faults, stop using the multi-function jump starter
and contact your dealer.
Fault
The battery status is indicated as
100% but the battery has not
been fully charged.
Pressing the button does not
have any effect.
FREQUENTLY ASKED QUESTIONS (FAQ)
Q: How can I switch off the device?
This device has an intelligent detection function. If no load is detected or the charging
1
A:
process is finished, the device switches off automatically. This protects the rechargeable
battery against deep discharge or overcharge, and increases the service life.
Q: How long does it take to fully charge the multi-function jump starter?
2
A: It takes approx. 3 to 4 hours when using a 5V/1.5A charge cable.
Q:
How long does it take to charge a mobile phone with it?
3
A: It takes about 1 to 2 hours to fully charge the telephone.
Q: How often can the device be used as jump starter if the battery status is 100%?
5
This depends on many factors such as, engine type, outside temperature, etc. In the
A:
most favourable case you can carry out up to 20 jump starting processes.
Q: How can I take care of the device when not in use?
The recommended storage temperature is between 0°C to 40°C.
6
Please keep the device away from fluids, open flames or radiators.
A:
Do not store the device in a moist location. The storage duration is 3 to 6 months.
Charge the product every 3 months to extend the service life.
For starting a vehicle, how long can I store the jump starter if it was charged to 100%
Q:
when starting the charging.
7
If the product indicates a battery status of more than 50% after a storage time of 3 to 6
A:
months, normally the device can be used as jump starter. With a battery status from
10%, the device can be used to charge smartphones, tablets, etc.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Cause
If the battery status is displayed
with 100%, this could be
because it has been stored /
not been used for a longer
period.
Safety circuit for a low battery
status is active and the device
cannot be switched on.
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
Solution
Disconnect the charging
connector from the multi-
function jump starter and
then connect again
immediately.
Charge the multi-function
jump starter.
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed