Troubleshooting - BGS technic 3381 Manual Del Usuario

2. Connect the red jump starter terminal with the Battery
positive and black jump starter terminal with Battery
negative.
3. Connect the connector of the jump starter cable with the
jump starter socket on the device.
4. Turn the ignition key to "ON" and start the engine.
Attention: do not carry out any longer start attempts. After
making start attempts of max. 3 seconds, take a break of at
least 10 minutes. Otherwise the device or its cables may be
damaged.
5. As soon as the engine starts to run, disconnect the jump
starter cable from the device and remove the jump
starter terminals from the vehicle battery.
CHARGING 5V USB DEVICES
1. Select the USB charge cable.
Connect the USB connector with the 5V USB output socket.
2. Connect the charge cable, Micro USB or "Lightning" connector for
Apple to the device to be charged, e.g. Table, smartphone, etc.
3. Press the button: the device switches on and the charging
process begins. The device connected such as tablet,
smartphone, etc. is charged.

TROUBLESHOOTING

If the following table does not lead to the correction of faults, stop using the multi-function jump starter
and contact your dealer.
Fault
The battery status is indicated as
100% but the battery has not
been fully charged.
Pressing the button does not
have any effect.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Cause
If the battery status is displayed
with 100%, this could be
because it has been stored /
not been used for a longer
period.
Safety circuit for a low battery
status is active and the device
cannot be switched on.
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
Solution
Disconnect the charging
connector from the multi-
function jump starter and
then connect again
immediately.
Charge the multi-function
jump starter.
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed