Inglesina zippy Manual De Instrucciones página 28

FRONT WHEELS BLOCKING/RELEASE
fi g. 17 The frame is equipped with pivoting
wheels that can be blocked or released simply
by acting on the lever N positioned on the front
wheels.
REAR PLATFORM
fi g. 18 Act with the foot on the rear platform to
ease the crossing of obstacles.
FEEDING BOTTLE HOLDING UNIT
fi g. 19 Hook the feeding bottle holding unit to
the frame and make sure it is properly in its seat.
STORAGE BASKET
fi g. 20 The frame is equipped with a capacious
storage basket. To secure it, insert all buttonholes in
the proper hooks and button up the rear strips.
HOOKING OF ADDITIONAL TRANSPORT UNITS
TO THE FRAME (CARRYCOT AND CAR SEAT)
fi g. 21 It is possible to hook the carrycot Zippy
C1 or the car seat Huggy C2 to the frame. For the
correct installation procedures refer to the dedica-
ted instruction manuals.
HOOKING OF THE BACKREST TO COVERT THE
FRAME INTO A STROLLER
fi g. 22 It is possible to hook to the frame the
backrest equipped with padding O to obtain the
stroller confi guration.
fi g. 23 Insert the buckle P in the proper but-
tonhole positioned on the rear side of the seat sup-
port.
fi g. 24 Insert the 2 ends Q on the pins R on both
sides of the frame.
fi g. 25 Hook the ends Q until hearing a CLICK
confi rming the hooking. Make sure that perfect
hooking occurred on both sides. In case of need, to
unhook the ends Q, press the element S and simul-
taneously pull the ends until the same are extracted
completely.
fi g. 26 Insert the backrest adjusting levers T in
the proper seats U on both sides of the frame until
hearing a CLICK confi rming the hooking.
fi g. 27 Make sure that perfect hooking occurred
on both sides. In case of need, to unhook the levers
T press the push-button V and simultaneously pull
the ends.
fi g. 28 Insert the buckle of the crotch strap Z in
the proper buttonhole on the front side of the seat
support.
fi g. 29 Insert the levers A1 of the footrest in the
proper openings on the covering.
28
INSTRUCTIONS
fi g. 30
vering as shown in fi gure.
fi g. 31
proper seat on the armrest. When seating the baby,
always make sure that the armrest cover is properly
hooked.
fi g. 32
the Stroller seat.
fi g. 33
allow the hooking of the carrycot and of the car seat
also in the Stroller version. With the index fi nger
press the hooking lever D1 positioned inside the ar-
mrest. To re-assemble it, insert the front part in the
opening on the armrest and press downwards.
ADJUSTMENT OF THE BACKREST
fi g. 34
positions; act on the central device E1 and bring the
backrest to the wished position.
USE OF THE HANDRAIL
fi g. 35
serting the ends in the openings on the armrests
G1 and then press until they block.
fi g. 36
or completely removed. To open it, press the red
lever H1 present under the armrest. To remove it,
repeat the procedure also on the other side.
CAUTION: do not insert the fi ngers in the ope-
nings on the armrests when performing these
procedures.
ADJUSTMENT OF THE FOOTREST PLATFORM
fi g. 37
I1 positioned on the lower part of the same and si-
multaneously press it downwards.
fi g. 38
will block automatically.
SAFETY BELTS
fi g. 39
central buckle.
fi g. 40
gh the side rings L1 and, when being used, it must
be adjusted in order to properly secure the baby.
fi g. 41
to the rings of the central buckle M1.
fi g. 42
with the waist one, adjusting both of them proper-
ly.
CAUTION: the inobservance of this precaution
may result in the falling or sliding out of the
baby with a resulting risk of injury.
Fasten the armrest covers B1 to the co-
Then, hook the armrest cover B1 to its
Hook the buttons C1 of the covering to
The armrest cover B1 can be removed to
It is possible to adjust the backrest to 4
Hook the handrail F1 with covering, in-
The handrail can be opened on one side
To lower the platform act on both levers
To lift the platform just pull it upwards: it
Fasten the ends of the waist belt to the
The waist strap must always pass throu-
Hook the snap hooks of the back straps
Always use the crotch strap together