Intended Use - Ratio LR260NM Manual De Instrucciones

OPERATION
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE

The machine is intended for dry sanding of wood,
plastic, filler and coated surfaces.
1. FITTING THE SANDING PAPER
SANDING PAPER WITH HOOK & LOOP
SYSTEM
FIT THE SANDING PAPER (See Fig A)
The sanding papers are placed directly onto the
base plate. The hole pattern in the base plate
and sanding paper must match. Then press
the sanding paper onto the base plate by hand.
Firmly press the power tool with the sanding
paper against a flat surface and briefly switch the
power tool on. This provides for good adhesion
and prevents premature wear
Before placing on the sanding paper, free the
base plate from dust/debris by lightly tapping
against it.
REMOVE THE SANDING PAPER
Simply remove the sanding paper directly.
A
SANDING PAPER WITHOUT HOOK & LOOP
SYSTEM (SEE FIG B , C , D)
FIT THE SANDING PAPER
Fit the sanding paper over the base. Make sure the
sanding paper is even with the edges and that the
dust collection holes in the base and sanding paper is
aligned and that the sanding paper is taut on the base.
Lift the sanding paper retaining clips to the open
position and insert one end of the sanding paper
under the retaining clip.
Push the clip back into the retaining position. Lightly
stretch the paper over the base plate ensuring that
it is not folded or wrinkled then position under the
other retaining clip back into the retaining position.
Check that the paper is flat to the base plate, if not,
28
release either clip and reposition the paper before
resetting the clip. Switch on momentarily to check that
the sander is functioning correctly. If there is undue
vibration, repeat the paper positioning procedure.
REMOVE THE SANDING PAPER
To remove the sanding paper, lift up the clamp lever
and move away from the clamp lever lock. The
sanding paper clamp is now loose. Repeat with the
other clamp on the opposite side of your sander.
B
C
D
2. USING THE CYCLONIC DUST BOX
A) ATTACH THE CYCLONIC DUST BOX (SEE
FIG E1)
Your sander is equipped with a cyclonic dust box.
To attach, slide the box onto the outlet piece and
take care that the latching lever engages.
CAUTION: To prevent the possibility of
sanding dust or foreign body being thrown
into your face or eyes, never attempt to use your
sander without the dust box properly installed.