Safe Operation; Installation And Connection; Protective Measures; Connecting The Antenna - Oase FM-Master Manual De Instrucciones

4.3

Safe operation

• Operation of the unit is only permitted with the protection hood fitted. This protects connections and plugs
from rain and splash water.
• The unit, the connections and plugs are not water-proof and must not be routed or installed in water.
• Never operate the unit if either the electrical cables or the housing are defective!
• Do not carry or pull the unit by its electrical cable.
• Route cords/hoses/lines in a way that they are protected against damage, and ensure that they do not pre-
sent a tripping obstacle.
• Only open the unit housing or its attendant components, when this is explicitly required in the operating in-
structions.
• Only execute work on the unit that is described in this manual. If problems cannot be overcome, please con-
tact an authorised customer service point or, when in doubt, the manufacturer.
• Only use original spare parts and accessories for the unit.
• Never carry out technical modifications to the unit.
5

Installation and connection

Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.

Protective measures:

• Only operate the unit with the protection hood fitted.
• Ensure that the unit is installed in a flood protected position at a distance of at least 2 m from the water.
5.1

Connecting the antenna

How to proceed:
 C
1. Remove the blind plug and screw the antenna into place.
2. Align the antenna.
5.2

Set-up the unit

How to proceed:
 B
• Install the unit at least 2 m from the edge of the pond.
• Do not expose the unit to direct sunlight.
 D
1. Remove the protection hood from the unit.
2. Insert the ground stake by approx. ¾ of its length into the ground.
3. Slide the device onto the ground stake.
4. With the unit, push the ground stake fully into the ground.
5. Check its stability.
5.3

Connecting the power supply

How to proceed:
 E
Unit version with power plug:
• Push the coupling of the power cable onto the unit plug.
 F
Unit version with power cable:
• Connect the unit to the power supply.
– Work on the power supply may only be carried out by a qualified electrician.
– Adhere to the pin assignment specified on the power cable label.
– Only use wires with wire end ferrules for connection.
- EN -
25