Before Use - Probuilder 62762 Manual De Instrucciones

Pull the starter handle (8) all the way out
until the engine starts. Repeat if the engine
fails to start � rst time.
Set the choke (6) to the open position once
the engine is warm.
Do not allow the starter handle to recoil onto
the generator. Allow the cable to rewind
slowly.
Never pull the starter handle when the
engine is running to avoid damage to the
engine.
Stopping the engine
Switch off or disconnect all electrical
equipment before stopping the engine.
Set the main switch (5) to the OFF position.
Turn the petrol cock (7) to the OFF position.

Before use

Start the engine as described above and
allow it to idle for approx. 3 minutes.
Check the engine runs smoothly and that
there are no abnormal sounds or vibrations.
Stop the engine and have it checked by an
authorised workshop if anything abnormal
occurs.
42
Use
Connect a heavy-duty cable between the
generator's earth terminal and an external
earth connection.
Connect the devices to be powered to the
power outlets (3).
Switch on the connected devices one at a
time, never simultaneously. Start the device
that uses most power � rst.
Never use � oodlights with other types of
electrical equipment.
If a device is defective, runs too slowly or
suddenly stops when connected to the
generator, switch it off immediately. Check
the connected device for defects.
NB! Stay within the rated power limit of the
generator as far as possible.
If the generator is overloaded, the circuit
breaker will trigger and switch off the
generator. Switch off the engine, turn off
one or more of the connected appliances
and press the reset button (4). Restart the
generator and continue with a lower load.
The generator must not operate at maximum
output for more than 30 minutes!