[Heading goes here]
Installation (continued)
6
Mounting the unit to the wall
NOTE: For safety reasons, it is imperative that this unit
be mounted to the wall.
NOTE: Before cutting, drilling or hammering into any wall
surface, verify the location of electrical, plumbing and gas
lines. Cutting any of these may cause serious injury.
□ Make sure the assembly is level. If not, adjust the feet (CC)
as needed.
□ Mark mounting points on the wall through the holes in the
top panels (B).
□ Hammer wall anchors (EE) into the wall, unless the mounting
screws (DD) will go directly into a stud.
□ Place the unit against the wall, lining up the wall anchors (EE)
and holes in the top side panels (B).
□ Tighten the mounting screws (DD) into studs or wall anchors (EE).
Care and Cleaning
□ Cleaning with a dry cloth may be sufficient.
□ For other stains or marks, wipe gently with a damp cloth.
□ Do not use strong detergents or abrasive cleaners; they may damage the surface of this product.
9
Please contact 1-855-HD-GLACIER for further assistance.
EE
DD
HOMEDEPOT.COM /GLACIERBAY
B