Surface Mount Installation; Safety Information; Care And Cleaning - Glacier bay 83012 Guía De Uso Y Cuidado

Surface Mount Installation

1
DETERMINING THE MOUNTING LOCATION
NOTE: Before installing, make sure all parts are
present. Compare parts with the Hardware Included
list. If any part is missing or damaged, do not attempt
to install the product.
□ Determine the desired mounting location, and
mark the wall where the unit will be installed.
3
INSTALLING THE CABINET
□
For wall stud installation, insert #12 x 3 in. screws
with washers (not included) through the pre-drilled
cabinet holes and into the stud locations.
□ For drywall installation, drill holes at the appropriate
locations and insert toggle bolts with washers (not
included) through the pre-drilled cabinet holes and
into the drywall.
□ For concrete wall installation, drill 1/4 in. holes at the
appropriate locations and insert #12 wall anchors
(not included) into the holes. Then insert #12 x 3 in.
screws, (not included) through the pre-drilled cabinet
holes and into the anchors.

Safety Information

Please read and understand this entire manual before attempting to assemble, operate, or install the product.

Care and Cleaning

□ Use a water-dampened cloth to clean the bath storage cabinet frame.
□ For the mirrors, use ammonia-free cleaning products.
Warranty
LIMITED WARRANTY
WHAT IS COVERED
The manufacturer warrants its parts and products to be free of substantial defects in materials and workmanship from the original date of
purchase under normal home use. This warranty is offered only to the original consumer purchaser and may not be transferred.
Coverage for the Medicine or Bath Storage Cabinet Body is for the lifetime of the product.
Coverage for Medicine Cabinet and Bath Storage parts (mirrors, doors, hinges and shelves) lasts for five years from the original date of
purchase.
During the warranty period, the manufacturer, at its option, will repair or replace any part or product that proves to have substantial defects
in materials or workmanship, or the manufacturer will provide an equivalent replacement product. In keeping with our policy of continuous
2
PRE-DRILLING THE BACK OF THE CABINET
□ Drill 1/8 in. diameter holes through the back
panel of the cabinet
4
INSTALLING THE SHELVES
□ Insert the left shelf clips (AA) into the holes on the left
side of the cabinet. Repeat on the right side (BB).
□ Rest the shelves (CC) on the shelf clips (AA & BB).
Please contact 1-855-HD-GLACIER for further assistance.
on all four corners.
HOMEDEPOT.COM/GLACIERBAY
BB
AA
CC