Instructions For The User; Setting The Water Temperature; Switching The Appliance Off - Ariston Thermo SGA X 120 Instrucciones Para El Uso Y La Manutención

INSTRUCTIONS FOR THE USER

WARNING!
Installation, first ignition and maintenance
work must be performed by qualified per-
sonnel only, in accordance with the in-
structions provided.
Incorrect installation may harm individu-
als, animals or property; the manufacturer
will not be held responsible for any dam-
age caused as a result. If the appliance is
installed inside the apartment, make sure
A
that all provisions relating to the air inlet
and room ventilation (in compliance with
current legislation) are respected.
IGNITION PROCEDURE
C
A
C
Turn knob B from
Press knob B fully in and hold it there; now
press the piezoelectric igniter C.
Check for a flame though hole A. Once
the flame is on, continue holding knob B
pressed in for a further 20 seconds or so.
If the pilot flame does not stay on, repeat
the above procedure.
B
B
(off) to (pilot).
C

SETTING THE WATER TEMPERATURE

Knob B can be used to set the hot water
temperature.
Turn the knob from the ignition position
to the index corresponding to the desired
temperature: from 1 to 7.
For an higher availability of hot water, it is
advisable to leave the knob to position (5)
and to mix the water to get the desired tem-
perature.
Hot water dispensed at temperature
above 50°C may immediately cause
severe burns.
The temperature of the water in the
product may rise over this threshold,
in particular after prolonged periods
of inactivity, due to the high thermal
insulation. Always check the tempera-
ture of the water before using it.
It is advisable to use a thermostatic
mixing valve.

SWITCHING THE APPLIANCE OFF

To switch the appliance off, turn knob B
to (off).
It is advisable to turn off the product in
case of prolonged periods of inactivity.
B
CAUTION!
GB
23