STEP 7
Setting up the Bracket
Refer to figure 7.1 for
instructions on preparing your
door hanging locations.
Finding Hole Locations
Refer to Figure 7.2 to
determine door mounting
hole locations. Transfer these
dimensions to your door from
the bottom and mark where
the holes should be. Pre-drill
these hole locations with a
3/32 drill bit. Be sure to not
drill all the way through the
door.
Securing the Brackets
Align the door mount bracket
with the pre-drilled holes in
your door. Secure your door to
the door mount bracket and
door mount support brackets
with the #8x3/4" flat head
screws. Use the adjustable
door mount bracket extension
pieces to align horizontally.
At this time, secure your door
mount support brackets to the
door and also tightly secure
them to the frame.
(See Fig 7.3)
#2
3
32
STEP 8
Secure the grommet to the
frame (See Figure 8). Re-insert
the padded mat at this time.
STEP 9
Insert waste container(s) (sold
separately) into the frame.
(See Figure 9)
4
FIGURE 7.1
ADJUST DOOR
MOUNT BRACKET
HORIZONTALLY TO
BE AT THE CENTER
OF THE THICK PART
OF DOOR
MINIMUM
16.5"
BRACKET
SCREWS
MINIMUM
ARE PART
16.5"
NO. 8
FIGURE 7.3
PART NO. 8
DOOR SUPPORT BRACKETS (PART NO. 17) SHOULD
BE MOUNTED TO THICK PART* OF THE DOOR
FIGURE 7.4
HORIZONTAL
TILT
ADJUSTMENT
JAMB
SCREWS
HORIZONTAL
TILT
ADJUSTMENT
FIGURE 8
PART NO. 12
Customer Service: 800-626-1126 | rev-a-shelf.com
1)
Make sure that your unit is securely installed into your cabinet. Remove the cabine
1.
Measure from cabinet opening to top bracket slot________
hinges to begin to mount your door.
1)
Make sure that your unit is securely installed into your cabinet. Remove the cabine
Measure from cabinet opening to bottom bracket slot________
hinges to begin to mount your door.
2)
Using the (4) provided screws and nuts, attach the L-Brackets to your slide.
2.
Note: Depending on your particular basket design L-Bracket will mount on either ins
Measure Cabinet Opening Height (a) ________
2)
outside of wire.
Using the (4) provided screws and nuts, attach the L-Brackets to your slide.
Note: Depending on your particular basket design L-Bracket will mount on either ins
Measure Door Height (b) ________
outside of wire.
Height Difference ________
Divide Difference by 2 ________
3.
If your door is larger than cabinet
opening, add the divided
difference you found in step 2
to the measurements in step 1.
Inside wire shown
If your door is smaller, subtract
the divided difference from the
Inside wire shown
measurements in step 1.
3a)
Attach the door brackets to the outside of the L-brackets using the (4) provided
3a)
Attach the door brackets to the outside of the L-brackets using the (4) provided
Top Measurement ________
*IF APPLICABLE
Bottom Measurement ________
12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service: 800-626-1126
FIGURE 7.2
(a)
(b)
Back side of
Cabinet Door
FIGURE 9
