Ocultar thumbs Ver también para 95-7366B:
Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Kia Sorento 2016-up
KIT FEATURES
• ISO DDIN radio provision
• Painted scratch resistant black
KIT COMPONENTS
• A) Radio trim panel • B) Radio brackets
A
B
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • 70-7304, HYBL-04
Antenna Adapter: • Not required
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver • 10mm Socket wrench • Cutting tool
METRA. The World's best kits.
Installation instructions for part 95-7366B
95-7366B
metraonline.com
Table of Contents
Dash Disassembly ................................................. 2
Kit Preparation ....................................................... 2
Kit Assembly .......................................................... 3
CAUTION!
Metra recommends disconnecting the negative bat -
tery terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your local
Dealership for more information. All accessories, switches, climate
controls panels, and especially air bag indicator lights must be con -
nected before reconnecting the battery or cycling the ignition. Also,
do not remove the factory radio with the key in the on position, or the
vehicle running. It would be best to remove the key from the ignition
and then wait a few seconds before removing the factory radio.
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
Tabla de contenido
loading

Resumen de contenidos para Metra 95-7366B

  • Página 5: Kia Sorento 2016 Y Mas

    Instrucciones de instalación para la pieza 95-7366B Indice Kia Sorento 2016 y mas 95-7366B Desmontaje tablero ..........2 Preparación del kit ..........2 Ensamble del kit ............ 3 CARACTERÍSTICAS DEL KIT • Provisión de radio ISO DDIN • Negro resistente a los arañazos de dolor COMPONENTES DEL KIT •...
  • Página 6: Desmontaje Tablero

    95-7366B Desmontaje tablero Preparación del kit 1. Desenganche y quite panel de 1. Corte el área marcada en el 2. Retire (1) tuerca de 10mm moldura del radio de fábrica, cavidad tablero. (Figura A) celebración del área cortada incluyendo las rejillas. (Figura A) previamente en el paso 1 para eliminar el área de corte.
  • Página 7: Ensamble Del Kit

    (Figura A) 2. Localice el arnés de cableado de fábrica y el conector de la antena en el tablero. Metra recomienda que use adaptadores adecuados de acoplamiento de Metra y/o de AXXESS. Vuelva a conectar la terminal negativa de la batería y...
  • Página 8: Importante

    Instrucciones de instalación para la pieza 95-7366B IMPORTANTE Si tiene dificultades con la instalación de este producto, llame a nuestra línea de soporte técnico al 1-800-253-TECH. Antes de hacerlo, revise las instrucciones por segunda vez y asegúrese de que la instalación se haya realizado exactamente...

Tabla de contenido