Rosewill RMS-MT6020 Manual Del Usuario página 5

TILT WALL MOUNT FOR LCD, PLASMA, and LED DISPLAYS
4. Insert a concrete anchor (C) into each hole so that it is flush with the
concrete surface. A hammer can be used to lightly tap the anchors into place
if necessary.
NOTE: If the concrete wall is covered by a layer of plaster or drywall, the
concrete anchor must pass completely through the layer to rest flush with the
concrete surface.
5. Place the wall plate back against the wall and attach it using the lag bolts (A)
and lag bolt washers (B) provided. Do not over-tighten these
bolts and do not release the wall plate until all bolts are in
place. Ensure that the wall plate remains level after all bolts are
secured.
Part 2 – Attaching the Mount Arms to the Display
IMPORTANT! Use extra care during this part of the installation. If possible, avoid placing your display facedown
as it may damage the viewing surface.
NOTE: This mount comes with a selection of different screw diameters and lengths to accommodate a wide
variety of display models. Not all of the hardware in the kit will be used. If you cannot find the appropriate screw
size in the kit provided, consult the manufacturer of your display for more information.
1. Determine the correct length of screw to use by examining the back of your display:
A. If the back of your display is flat and the mounting holes are flush with the surface, you will use
the shorter screws (D or F) from the hardware kit.
B. If the back of your display is curved, has a protrusion, or if the mounting holes are recessed, you
will need to use the longer screws (E or G) and the spacers (I).
2. Determine the correct diameter of screw to use by carefully trying one of each size (M6 and M8) from
the hardware kit. Do not force any of the screws – if you feel resistance stop immediately and
try a smaller diameter screw.
3. Attach the mount arms to the back of your display using the screws identified in Steps 1 and 2:
A. If you are using the M6 screws you will also need to use the M6 washers (H). M8 screws do not
require washers.
B. If you are using the longer screws on a display with a curved or recessed back, you may also
need to use the spacers (I). Use one spacer or two spacers stacked as needed. Only use a
spacer if necessary.
For screens with flat
back.
For screens with curved
back or behind.
4
RMS-MT6020 User Manual