Tabla de contenido
Idiomas disponibles
Idiomas disponibles
16 INSTALLATION
Step11: Connecting Power
1
Before beginning, turn off electrical power to the
unit at the circuit breaker.
2
Remove the junction box cover and then install
the strain relief.
1
3
Twist the wire nuts tightly onto the wires; then
wrap each connection with electrical tape.
1
2
4
Check again and make sure that all wires are
connected correctly: black to black, white to
white, green ground wire to green ground wire.
5
Replace the junction box cover.
WARNING
Verify that the black wire is hot (120 V). If not,
or if you are unsure of the power supply, have it
checked by a licensed electrician.
CAUTION
Do not leave stripped wire exposed. Trim stripped
wire to fit completely inside wire nuts.
2
3
4
Junction box
Step12: Final Check
1
Turn on electrical power.
2
Turn on house water supply.
3
Make sure the door opens and closes smoothly.
If necessary, level the dishwasher again.
4
Run the dishwasher on a Normal cycle to verify
proper operation and check for leaks.
CAUTION
Only install the lower cover provided with the
machine. Do not install cabinet baseboard as it
may cause noise and leakage.
Cabinet
baseboard
Error Code
Possible Cause and Solution
Drain hose kinked or pinched.
Pull on the drain hose while sliding the
dishwasher into place. Do not allow any
slack in the hoses behind the dishwasher.
OE Error
Drain hose connected to disposal.
Remove knockout on disposal.
Waste tee is clogged.
Remove knockout plug on waste tee.
Water supply line kinked under
dishwasher.
Pull on the water supply line while
sliding the dishwasher into place. Do not
IE Error
allow any slack in the hoses behind the
dishwasher.
House water supply not turned on.
Turn water on.
Lower cover
Capítulos
Tabla de contenido
