12 INSTALLATION
Step5: Removing Lower
Cover
1
Remove the two screws attaching the lower
cover to the dishwasher.
2
Remove the lower cover from the base. Remove
the insulation pad from behind the access panel.
NOTE
If at any time the dishwasher is laid on its back,
take care not to damage the drain hose.
Step6: Sliding Dishwasher
into Cabinet
1
Before sliding the unit completely into place you
will need to attach the installation brackets.
Installation
bracket
2
Before sliding the dishwasher into place, raise
the dishwasher by adjusting the front and rear
legs of the dishwasher to the approximate height
of the opening. Although you will need to make
fine adjustments after it is in place, this method
will minimize those adjustments.
3
Make sure the water supply line hose and
electrical supply line are routed through the
designated hooks beside the sump.
Water
Electrical
supply line
supply
4
Slide the dishwasher carefully into the cabinet
opening.
CAUTION
• To avoid a kinked or pinched drain hose, be
sure to pull on the drain hose while sliding the
dishwasher into place. Do not allow any slack
behind the dishwasher.
• After leveling the dishwasher, do not leave the
water supply line or power supply line under the
sump. This is a potential cause of water leaks.
Place the water line and the power supply line
beside the sump.
Adjusting the Legs
Adjust the rear legs of the dishwasher using the
screws just above the front legs of the dishwasher.
Use a Phillips #2 screwdriver to make the
adjustments.
To raise the back of the dishwasher, lower the legs by
turning the screw in the direction of the arrow printed
on the base of the unit. To lower the rear of the
dishwasher, turn the screw in the direction opposite to
the arrow.
NOTE
The right and left side rear adjustments are
opposites of each other.
For front leg adjustments use a
a socket. Place the ratchet directly onto the front
leg and turn it to the right to raise the front of the
dishwasher. Turn the ratchet to the left to lower the
front of the dishwasher. For the front legs the left and
right side adjustments work identically.
/
" ratchet without
1
4