Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALL DUCTWORK (DUCTED INSTALLATION ONLY)
1. Determine whether hood will discharge vertically
(3¼" x 10" or 7" Round) or horizontally (3¼" x 10"
only).
2. Run ductwork between the hood location and a roof
cap or wall cap.
3. Choose a straight, short duct run to allow the hood to
perform most effi ciently. Long duct runs, elbows and
transitions will reduce the performance of the hood.
Use as few of them as possible. When possible, use
at least 2 foot straight runs before any turns. Larger
ductwork may be required for best performance with
longer duct runs.
4. Install wall cap or roof cap (sold separately). Connect
metal ductwork to cap and work back towards the
hood location. Use 2" metal foil duct tape to seal the
joints between ductwork sections.
1. If present, remove all protective polyfi lm from the
hood and/or parts. Using the fi nger cup, remove
the Hybrid Filters from the hood by pushing down
and tilting fi lters out.
2. Remove both fi llers by removing the 3 screws holding
each one of them. Slide each one towards the center
of the hood and tilt it up to remove it completely. Set
the fi llers and screws aside.
S
OFFIT
C
ABINET
18"
MIN
ABOVE COOKING SURFACE
NOTE: Distances over 30" are at the installer and user
PREPARE THE HOOD
7
R
OOF CAP
3¼"
7"
ROUND DUCT
(F
OR VERTICAL
DISCHARGE
H
OOD
- 30"
MAX
discretion.
B
C
10"
X
OR
)
H
OUSE WIRING
(T
)
OP OR BACK OF HOOD
W
ALL CAP
3¼"
10"
X
DUCT
(F
)
OR HORIZONTAL DISCHARGE
Capítulos
Tabla de contenido
