Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4. (This step is only for the vehicle that has Hands free lift gate) Using a phillips screwdriver and plastic trim tool, remove (2) screws and (1) push pin that hold the
sensor to lower the bumper fascia. Remove forward most sensor antenna (if present) and cover in provided corrugated plastic tubing. Push and adjust through hole in
main body plate. Using an electrical tape adhere the ends of antenna to corrugated plastic tubing.
5. Trim lower fascia – Using a tape measure, marker, and utility knife, measure, mark, and trim the lower fascia and sensor bracket (if present). See Figure 2 & 3.
��
��
©2020 Horizon Global Americas Inc. - Printed in Mexico
C
C C
L
L L
of Vehicle
of Vehicle
of Vehicle
"
"
��"
��"
Figure 2
Figure 3
Sheet 5 of 18
76342NP
10-12-20
Rev. A
Tabla de contenido
