Tabla de contenido
To remove the lower quick-release plate, toggle the lever on the camera mounting plate
to the unlocked position and remove the lower quick-release plate while pressing the
safety lock on the mounting plate.
RSS Camera Control Port
Safety Lock
4. Connect the Camera Control Cable
Choose the proper camera control cable according to the camera type. Plug one end
of the cable into the RSS camera control port of the gimbal (shown above) and plug the
other end into the camera.
Balancing
Balancing is required before shooting. Before balancing, make sure to power on the camera
if using an optical zoom lens and to select the focal length if using a varifocal lens. Make sure
DJI RS 2 is powered off or in sleep mode before balancing.
1. Balancing the Vertical Tilt
a. Unlock the tilt axis and loosen the mounting plate knob
b. Rotate the tilt axis so that the camera lens is pointing upward. Check to make sure
the camera is not top or bottom-heavy. If top-heavy, move the camera backward
bottom-heavy, move the camera forward
c. Tighten the mounting plate knob while holding the camera upward. The vertical tilt is
balanced when the camera is steady while pointing upward.
DJI RS 2 Quick Start Guide
.
1
.
2
1
2
©
2020 DJI OSMO All Rights Reserved.
. If
2
7
Tabla de contenido
