Before First Use; Use And Operation; Cleaning And Care - oneConcept 10026809 Manual De Instrucciones

• Remove all packaging and transportation safety devices from the device that may be
present.
• Rub all of the parts with a damp cloth. This will remove any dust that may have accumu-
lated during transport. Clean the permanent filter, the filter holder, the thermal stainless
steel cup and the lid by hand in a bowl of water.
• Reinsert all of the parts in the reverse order. Please use the recesses for the filter holder
and the permanent filter to help you.
• Before making coffee for the first time, allow water to pass through the device two to
three times in order to clean it
1. Fold open the water tank lid.
2. Fill the water tank with cold water. Do not overfill the tank! Do not fill above the marks
for the maximum quantity of water.
3. Fill coffe powder into the permanent filter. For a full thermal cup, we recommend approx.
15 g or approx. 7.5 g of coffee powder for half a cup. The permanent filter can contain a
max. of 20 g coffee powder. Do not overfill the filter. If it contains too much coffee powder
there is the risk that the ground coffee may spill over the edge of the filter.
4. Put the thermal cup on the cup shelf without the lid and close the lid of the water tank.
5. Position the switch in position „I". The brewing is started. The power indicator lamp lights
up. The preparation takes a max of 4.5 minutes. Take out the thermal cup after prepara-
tion. Close it with the lid. Keep the slider closed so that the coffee stays warm longer. The
slider is not a non-drip, leak proof seal!
6. Turn the device off. The control lamp goes out. If you would like ot make another cup of
coffee immediately, switch the device off. Allow it to cool down with the water tank open
in order to prevent hot water splashing out when the machine is refilled.
Descaling
• It is necessary to descale the coffee machine if the preparation time becomes considerably longer.
• Only a commercially available decalcifier on a citric acid base should be used for descaling.
• Please use the quantities stated on the pack or instruction leaflet. Note the maximum
water amount!
• Put the thermal cup without a lid or another suitable cup (approx. 300ml) onto the cup shelf.
• Afterwards you should boil fresh water in the pot three or four times in order to rinse out
residues of the descaling agent.
• Do not use any coffee powder! Do not use this water for consumption.
8

Before first Use

Use and Operation

Cleaning and Care