Rev-A-Shelf 5LB Serie Instrucciones De Instalación página 2

NOTE: THE BELOW STEPS SHOW INSTALLATION INTO A FRAMELESS CABINET. IF INSTALLING INTO
A FACE FRAME CABINET, YOUR CABINET SIDE WALLS WILL NEED TO BE MADE FLUSH WITH THE
FACE FRAME USING A SCAB BOARD. CABINET OPENING DIMENSIONS REMAIN CRUCIAL.
STEP 1
Use the measurements from
Figure 1 to mark the slide
mounting hole locations.
(recommended with an awl and
rubber mallet).
NOTE: If installing into a face
frame cabinet, the cabinet
side walls will need to be
made flush with the face
frame using a scab board.
STEP 2
Install slides in your cabinet
using #8 x 1/2" screws found
in 5LB slide mount screw pack
(See Fig 2).
#2
STEP 3
Place the frame on the slide at
an angle and then lay flat (See
Fig 3.1). Push back until you
hear a "click" (See Fig 3.2).
2
FIGURE 1
ALL HOLES ARE
1-1/2" (38 mm)
1-1/2"
FROM CABINET
(38 mm)
FLOOR
FIGURE 2
FIGURE 3.1
INSERT AT AN ANGLE
Customer Service: 800-626-1126 | rev-a-shelf.com
2-23/32"
(69 mm)
HOLE
LOCATIONS
1-15/32"
(37 mm)
FIGURE 3.2
PUSH UNTIL YOU HEAR A "CLICK"