Assembly And Adjustments - Shindaiwa M2510 Manual Del Propietário

Assembly and adjustments

Prior to assembly
This Shindaiwa Multipurpose Tool Carrier
comes fully assembled. You only need
attach the accessory tool of your choice to
the powerhead. Your Multipurpose tool
carrier includes:
Handle
Your Shindaiwa Multi-Purpose Tool Car-
rier comes with the handle installed. It can
be re-adjusted for operator comfort in the
following manner.
1. Loosen the four hex screws..
2. Rotate/slide handle assembly to best
position for operator comfort, usually
25 cm (10 in.) ahead of the throttle
assembly.
3. Tighten hex screws in a crisscross
manner.
Throttle lever free play
The throttle lever free play should be
approximately 4 - 6 mm. Make sure that
the throttle lever operates smoothly
without binding. If it becomes necessary to
adjust the lever free play, follow the proce-
dures and illustrations that follow.
1. Loosen the air cleaner cover knobs and
remove the air cleaner cover.
2. Loosen the lock nut on the cable
adjuster.
3. Turn the cable adjuster in or out as
required to obtain proper free play 4-6
mm (3/16-1/4 inch).
4. Tighten the locknut.
5. Reinstall the air cleaner cover.
This owner/operators's manual
Tool kit for routine maintenance. Tool
kits vary by model and may include a
hex wrench, and a spark plug/screw-
driver combination wrench.
Hex screws
Adjusting the handle
Throttle lever free play
Adjusting throttle lever free play
IMPORTANT!
The terms "left", "left-hand", and "LH";
"right", "right-hand", and "RH"; "front" and
"rear" refer to directions as viewed by the
operator during normal operation.
Handle
Moutning
plate
Rotate the cable adjuster as required to
obtain correct free play
4 - 6 mm
Cable
adjuster
4 - 6
mm
Throttle assembly
Outer tube
Lock nut
5