Care Of The Reciprocating Saw; Transport And Storage - Hilti WSR 36-A Manual De Instrucciones

5.11 Plunge cutting 9
WARNING
Risk of injury! Risk of kickback.
▶ Apply the appropriate safety measures at the rear of the workpiece when plunge sawing. Use only
suitable saw blades (length as short as possible).
Note
Use the plunge cutting technique only on soft materials and with short saw blades. The product can
be used in one of two plunge cutting positions: in the normal position or in the reversed position.
1. Bring the forward edge of the AVR contact shoe into contact with the workpiece.
2. Disengage the transport lock.
3. Press the control switch.
4. Press the forward edge of the contact shoe against the workpiece and begin the plunge action by slowly
increasing the angle of attack.
Note
To prevent stalling, it is important that the product is running before the saw blade is brought into
contact with the surface.
5. Once the saw blade has penetrated right through the material, bring the tool into the normal working
position (contact shoe flush with the workpiece) and then continue sawing along the cutting line.
6 Care, maintenance, transport and storage

6.1 Care of the reciprocating saw

WARNING
Electrical hazards. Improper repairs to electrical parts may lead to serious injuries.
▶ Electrical parts may be repaired only by trained electrical specialists.
▶ Keep the product, especially its grip surfaces, clean and free from oil and grease. Do not use
cleaning agents containing silicone.
▶ Never operate the product when the air vents are blocked. Clean the air vents carefully using a dry brush.
Do not allow foreign objects to enter the interior of the product.
▶ Clean the outside of the product at regular intervals with a slightly damp cloth. Do not use a spray, steam
pressure cleaning equipment or running water for cleaning.
Note
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables.
Spare parts, consumables and accessories approved by Hilti for use with the product can be
found at your local Hilti Center or online at: www.hilti.com

6.2 Transport and storage

Transport
CAUTION
Inadvertent starting during transport. Uncontrolled starting during transport may occur if the battery
is fitted, thereby resulting in damage to the tool.
▶ Always remove the battery before transporting the tool.
• Remove the battery.
• Transport the tool and battery individually packaged.
• Never transport batteries in bulk form (loose, unprotected).
• Check tools and batteries for damage before use after long periods of transport.
21