Cancellation Of A Reading; Temperature Monitoring; Thermal Paper Specifications; Replacement Of The Paper Roll - Bionova MiniPro Manual Del Usuario

Instructions for use

Cancellation of a reading

The user can cancel a reading of any of the 3 positions by
simultaneously pressing the button
and the button for 3 seconds. The device will cancel the
reading and the cancellation will be informed by printing a ticket.

Temperature monitoring

Bionova MiniPro Auto-reader contains an internal temperature
®
control. If the temperature falls outside of the specified range
60±2 ºC, the blue temperature led light will start to twinkle.
Temperature can be externally monitored by using a Bionova
TB-IC1020 thermometer or other similar. MiniPro Auto-reader
has a special hole for placing the thermometer which is located
at the right side of the device.

Thermal paper specifications

Recommended paper: JUJO AF50KSE3 or similar (order code
ICTP).
Paper width : 58 mm
Maximum paper thickness: 60 g/m
Maximum diameter size: 23 mm

Replacement of the paper roll

The printer uses thermal paper rolls.
of the chosen position
®
2
1.To replace the paper roll,
pull the handle of the prin-
ter's door. Open the printer's
cover and remove the spent
roll.
Bionova MiniPro Page 11
®
NOTE: You can check the correct paper replacement by
pressing , this button will force the advance of the
paper a few centimeters.

Setup Mode

Bionova MiniPro has a setup mode from which, the equipment
®
time zone and the print language can be set up. To enter Setup
Mode, turn on the auto-reader while holding down the button
. The red and green LEDs in the three positions will remain
on, indicating that the device is in this mode. The printer will
render a ticket indicating that it is in Setup Mode.
To change the time zone and the print language, follow the
instructions below. When finished, restart the computer to exit
Setup Mode.
Modification of time zone
The time zone modification function allows changing the time
zone of the device to suit the time zone of your country.
To make this change, the auto-reader must be started in Setup
Mode (see Setup Mode), then press the button
The current time will be printed to set a reference.
To subtract hours, press the button
necessary. To add hours, press the button
as necessary. After 2 seconds, a ticket will be printed informing
the selected time.
2.Place the new paper roll
with the outer side up.
3.Close the printer cover
by pressing on the sides of
the lid.
.
as many times as
as many times