Idiomas disponibles
Idiomas disponibles
B.
MODLED1F, MODLED2F, and MODLED3F.
1.
See figure 4. Position the LED Module/Bezel Assembly on the mounting
surface. Ensure that it is level side to side and the bezel drain hole is located at the bottom
Using the LED Module/Bezel Assembly as a template, scribe the four mounting holes and a
wire routing hole location on the mounting surface.
Before drilling holes in ANY part of a vehicle, be sure that both sides of the
mounting surface are clear of parts that could be damaged; such as brake lines,
fuel lines, electrical wiring or other vital parts.
2.
Drill four mounting holes (9/64") and an appropriate sized wire routing hole
at the previously scribed locations.
All drilled holes should be free of burrs and sharp edges. All wire routing holes
should be grommeted and/or sealed to avoid wire and/or vehicle damage.
3.
The MODLED1F is comprised of a single LED module, a chrome plated
surface mounting bezel, and a gasket. The module is designed with an integral connector
socket.
The MODLED2F is an assembly comprised of two LED modules, a wiring
harness, a chrome plated surface mounting bezel, and a gasket. The wiring harness is
designed so each module within the assembly can be controlled independently.
The MODLED3F is an assembly comprised of three LED modules , a wiring
harness, a chrome plated surface mounting bezel and a gasket. The wiring harness is
designed so that all three modules are controlled together.
The supplied accessory kit includes the mating connector components.
4.
Complete the electrical connections as described in Paragraph V. Electrical
Connections.
5.
Plug the connector into the LED module (MODLED1F) or wiring harness
(MODLED2F, MODLED3F).
6.
Align the LED Module/Bezel Assembly over the previously drilled holes.
Carefully tuck the connector (MODLED2F, MODLED3F) into the recessed area in the back of
the bezel. Secure the assembly in position with the provided #10 x 3/4" screws.
V.
ELECTRICAL CONNECTIONS.
Before proceeding, it is recommended to obtain the following:
Description
AMP Hand Tool Assembly
AMP Die Assembly
AMP Instruction Sheet
A.
See figure 2 (MODLED1, MODLED1F, MODLED3F) or figure 3 (MODLED2F).
Using user-supplied 18 AWG red and black wire and the provided connector components,
assemble the connector to the wires as follows:
CAUTION
CAUTION
AMP Part No.
58583-1
58583-2
408-4165
-3-
