7.
Set the unit upright and tighten all nuts and bolts
around the entire unit.
8. Insert the shelves (4) at your desired levels. (See Figure 7)
NOTE: In order to
place the shelves,
you must first tilt
the shelf slightly
to the left or right
before inserting
into the unit.
9. Attach the left door (8)
to the unit by placing
the door on the
hinges, aligning the
hinge holes, dropping
the hinge pins into
the slots, then placing
the flat end of a screwdriver on the hinge pins and
tapping them in with a hammer. (See Figure 8)
8
10. Attach the right door (9)
to the unit in the same
way you attached the
left door. (See Figure 9)
NOTE: If having
issues with
doors aligning,
it may be due
to cabinet not
sitting level. Use
included nut
driver to adjust
leveling feet in
bottom front two
corners. Nut driver
should insert through inside of cabinet
down into feet and adjust as needed.
PAGE 4 OF 12
ASSEMBLY CONTINUED
Figure 7
4
Figure 8
15
Figure 9
9
1-800-295-5510
HANDLE/LOCKING SYSTEM INSTALLATION
1.
Place the locking handle
(11) on the righthand door
and fasten with two #8-32
x 1/4" slotted hex head bolts
and lockwashers.
(See Figure 10)
2. Turn the handle to the
open position. Place
the locking cam (12)
over the square shank
of the door handle.
The latch must be
facing downward as
shown. (See Figure 11)
Place the cotter pin
(13) through the hole of
square shank.
(See Figure 12)
3. With the handle still in the open position, hook the
locking bars (10) to the locking cam. (See Figure 13)
Once in position, slowly rotate the door handle to
the closed position so the lock bars protrude from
the holes at the top and bottom of the door.
4. Slide the nylon lock bar guide inserts (14) over the
lock bar ends and through the door slots. Push firmly
until the guides snap into place. If necessary, turn
the handle back to the open position and gently
tap with a hammer until the guides slide into place.
(See Figure 14)
Figure 13
10
12
uline.com
Figure 10
11
Figure 11
13
12
Figure 12
Figure 14
14
14
0721 IH-8447