BGS technic 1514 Manual Del Usuario página 4

USE
Press sleeve
Spindle nut
1. Take a spindle, this must fit through center of the bearing. Always take the maximum matching
spindle diameter.
2. Take appropriate pressure sleeve, it must have approximately the same external diameter as the
bearing, however, must be smaller than the inner diameter of the bearing housing. This prevents
jamming of the pressure sleeve in the bearing housing.
3. Take a sleeve for counter holding, the inner diameter must be equal or greater than the outer
diameter of its bearing. This prevents jamming of the bearing in the counter holding sleeve.
Bush / Bearing
Press sleeve
1. Take a spindle, this must fit through center of the bearing. Always take the maximum spindle
diameter.
2. Take appropriate pressure sleeve, it must have approximately the same external diameter as the
bearing.
3. Take a sleeve for counter holding, the inner diameter must be greater than the outer diameter of its
bearing.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Pull sleeve
Bush / Bearing
Housing
Bush / Bearing
Housing
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
Disassembly
Mounting
Pull sleeve
Spindle
Bush / Bearing
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed