Bosch 3 600 HA1 1 Serie Manual De Instrucciones página 13

OBJ_BUCH-2280-001.book Page 13 Wednesday, July 30, 2014 11:29 AM
Protect the cable from heat, oil and
sharp edges.
 The extension lead must have a
cross section in accordance with the
operating instructions and be pro-
tected against splashed water. The
connection must not be in water.
Electrical Safety
 Motor Protector fitted! Motor fit-
ted with safety overload protec-
tion. If motor stops working, allow
a few minutes to cool, before re-
starting.
 Warning! Switch off, remove plug
from mains before adjusting,
cleaning or if cable is entangled.
 If a cord becomes damaged during
use, disconnect the supply cord
from the mains immediately. DO
NOT TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY.
Your machine is double insulated for
safety and requires no earth connec-
tion. The operating voltage is 230 V AC,
50 Hz (for non-EU countries 220 V,
240 V as applicable). Only use ap-
proved extension cables. Contact your
Bosch Service Centre for details.
Extension cords/leads should only be
used if they comply with H05VV-F,
H05RN-F types or IEC type design
(60227 IEC 53, 60245 IEC 57).
If you want to use an extension cable
when operating your product, only the
following cable dimensions should be
used:
2
– 1.0 mm : max. length 40 m
2
– 1.5 mm : max. length 60 m
2
– 2.5 mm : max. length 100 m
Bosch Power Tools
Note: If an extension cable is used it must
be earthed and connected through the
plug to the earth cable of your supply net-
work in accordance with prescribed safe-
ty regulations.
If in doubt contact a qualified electrician
or the nearest Bosch Service Centre.
 WARNING! Inadequate extension
cables can be dangerous. Exten-
sion cable, plug and socket must
be of watertight construction and
intended for outdoor use.
It is recommended for increased elec-
trical safety to use a Residual Current
Device (RCD) with a tripping current of
not more than 30 mA. Always check
your RCD every time you use it.
The connection lead must be inspected
for signs of damage at regular intervals
and may only be used if in perfect con-
dition.
If the supply cord is damaged, it must
be replaced by a Bosch Service Centre.
For products not sold in GB:
WARNING: For your safety, it is re-
quired that the plug attached to the ma-
chine is connected with the extension
cord. The coupling of the extension
cord must be protected against splash
water, be made of rubber or coated
with rubber. The extension cord must
be used with a cable strain relief.
Products sold in GB only: Your prod-
uct is fitted with a BS 1363/A approved
electric plug with internal fuse (ASTA
approved to BS 1362).
If the plug is not suitable for your socket
outlets, it should be cut off and an ap-
propriate plug fitted in its place by an
authorised customer service agent.
English | 13
F 016 L81 152 | (30.7.14)