Adjusting The Carburetor; Chain Brake; Stopping The Engine - Timberpro CS 2500 Manual Del Usuario

■ ADJUSTING THE CARBURETOR

The carburetor on your unit has been factory adjusted
and it is not allowed to be adjusted by the final user.

■ CHAIN BRAKE

The chain brake is a device which stops the chain in-
stantaneously if the chain saw recoils due to kickback.
Normally, the brake is activated automatically by inertial
force. It can also be activated manually by pushing the
brake lever (left-hand guard) down toward the front.
When the brake operates, a yellow cone pops up from
the base of the brake lever.
Releasing the Brake
Pull the brake lever up toward the left-hand handle until
it clicks into place.
WARNING
• When the brake operates, release the throttle lever
to slow down the engine speed. Continuous opera-
tion with the brake engaged will generate heat from
the clutch and may cause trouble.
• At machine inspection prior to each job, check the
operating condition of the brake following the steps.
1. Start the engine and grasp the handle securely with
both hands.
2. Pulling the throttle lever to maintain the chain opera-
tion, push the brake lever (left-hand guard) down
toward the front using the back of your left hand.
3. When the brake operates and the chain is stopped,
release the throttle lever.
4. Release the brake.

■ STOPPING THE ENGINE

1. Release the throttle lever to allow the engine to idle
for a few minutes.
2. Set the switch to the "O" (STOP) position.
GB 11
Release
Activate
the brake.
Switch