Tabla de contenido
Idiomas disponibles
Idiomas disponibles
8. Install hitch – Using the supplied pullwires
leave pullwires attached. Make sure weldnuts are free from rust and debris. Raise the hitch into position and align holes in hitch bracket to the frame rail
weldnuts guiding the pullwire ends through holes in the hitch bracket and loosely reinstall the M16 bumper bolts removed in step 4. Remove pullwires, install
l
conical washers
(teeth side toward hitch) and nuts
9. Tighten all M16 fasteners with torque wrench to 146 Ft.Lb. (198 N*M), 1/2" fasteners to 75 Ft.Lb. (102 N*M)
©2020, 2021 Horizon Global™ Corp - Printed in Mexico
n
install the carriage bolts ①and spacers ② into the vehicle frame through the center attachment, see Fig. 4,
m
, see Figure 1.
⑤
Kink pullwire to keep spacer independent of
bolt
A. Insert bolt and
B. Align block
Block into
on
access hole
frame
Figure 4
Proper torque is needed to keep the hitch secure to the vehicle when towing.
C. Pull bolt
thru block
Sheet 11 of 36
76320NP
5-27-21
Rev. D
Tabla de contenido
