Troubleshooting - Waring Commercial WCM50 Serie Manual Del Usuario

6. Gently but firmly pull down on the spray head to unlatch it.
7. Wipe inside of brew head and area around the brew head with
a soft, clean cloth or sponge moistened with clean water.
8. Wash the spray head in a sink using warm water and a mild
detergent. A soft bristle brush may be used to clear clogged
spray holes. Rinse the spray disk with clean water and allow
to air-dry.
9. Once dry, reinstall the spray head under the brew head.
10. It's recommended to clean the spray head at the end of every
service week.
11. Wash the brew basket in a sink using warm water and a mild
detergent. A soft bristle brush may be used to clean the inside.
Rinse with clean water and allow to air-dry.
NOTE: In hard-water areas, this may need to be done more
frequently. It will help prevent liming problems in the brewer, and
takes less than a minute to complete.

TROUBLESHOOTING

A troubleshooting guide is provided to suggest probable causes
and remedies for the most likely problems encountered. If the
problem remains after exhausting the troubleshooting steps,
contact the Waring Technical Service Department.
If unit will not brew, check the following before calling for service:
1. Is the unit plugged in?
2. Was water poured into the unit?
3. Is the lower warmer/brew switch in the ON position?
4. Inspection, testing, and repair of electrical equipment should be
performed only by qualified service personnel.
5. Make certain that all electrical connections are tight and isolated.
If unit will not brew, check the following before calling customer
service.
Water won't heat.
a. Brewer may be unplugged. Check power supply cord or check
circuit breaker.
b. You may not have enough water or too little water added at
start-up. Be sure to add sufficient water.
Coffee level low.
a. In this case, you may not have poured in enough water. Increase
the amount of water.
10