Tabla de contenido
Document Feeder Options
Depending on the configuration ordered, three feeder types are available:
1. Full Feeder (FF):
2. Small Feeder (SF):
3. Single Document
Feeder (1F):
The feeder is designed so that checks can be loaded
continuously, while the scanner is processing. This can be done
by inserting checks behind those already present in the feeder.
Removing Documents from Pocket
Processed documents are sent to the exit pocket. For best result,
follow these recommendations:
Remove the documents when the pocket is nearly full. Jams
occur when the pocket is too full. No "pocket-full" sensor is
available.
Occasionally verify that the endorsements are clearly printed.
Occasionally verify that the images are being properly captured and that the image quality is good.
OPERATOR MANUAL
Designed for both single document
automatic insertion and up to 100
document batch processing.
Designed for both single document
automatic insertion and up to 50
document batch processing.
Designed to process documents
one at a time with single document
automatic insertion.
Page 24
Note: The small feeder option causes the
automatic document feeding operation to
stop, followed by a system warning message,
after 50 consecutive documents have been
processed, according to the ordered
configuration. The feeder sensor must then
be cleared by removing the documents from
the feeder and then repositioning and
restarting the application. All other features
are the same as the Full Feeder.
This option is reset if the feeder is emptied
before the 50 document limit is met for the 50
documents limited feeder.
Getting Started
Tabla de contenido
