cecotec Conga 2690 Manual De Instrucciones página 41

Remove and clean the side brushes regularly.
Note: In order to ensure a perfect cleaning, it is suggested to replace the side brushes every 3
months.
Free-fall sensors
Fig. 32.
Clean the free-fall sensors with a soft cloth regularly.
Recommendation: Clean the camera regularly with a soft cloth.
Warning: Always transport the product turned off and in its original package.
Jalisco brush
To clean the Cepillo Jalisco brush, wash it with water. Dry it thoroughly before assembling it
back in order to ensure efficient operation.
Battery replacement and charging
Do not use any other battery, power adapter or charging base than the one officially provided by
Cecotec.
Do not use non-rechargeable batteries.
Do not remove, dismantle or attempt to repair the battery or the charging base.
Do not place the charging base near heat sources.
Do not use a wet cloth to wipe any of the parts of this product.
If the robot is not going to be used for a long time, remove the battery from the product and
store it in a dry and safe place. It is suggested to charge the battery every month in order to
avoid damage to the battery.
Do not dispose of waste batteries at will. It is suggested to hand them over to professional
organizations for correct treatment.
8. TROUBLESHOOTING
Problem
The robot does not start up or does not clean.
Solution
The robot cannot operate when the battery is
low. Allow it to charge before operating it.
The room temperature is below 0 ºC or above
50 ºC. Operate the robot in a room where
the temperature is between the stated
temperature range.
ENGLISH
41