cecotec Conga 2690 Manual De Instrucciones página 39

ENGLISH
Use the App to enter the water intensity mode and select between low, medium or high.
Warnings:
Do not use the mop outdoors.
Remove the carpets before operating the robot under this mode.
During operation, control the water level on the Wet & dry tank. If it empties, fill it up again
before continuing scrubbing.
Take the Wet & dry tank and the mop out before charging the robot.
Note: In order to ensure perfect scrubbing, moisten the mop before starting scrubbing.
Manual
Use the direction buttons on the remote control or on the App to take the robot to the specific
points where you want it to clean.
Back home mode
This mode can be activated from the robot, the App or the remote control at any point of any
cleaning cycle.
Once it is activated, the robot will automatically return to the charging base.
Spiral mode
Select this mode for the robot to carry out an intensive cleaning of a specific spot. It will start
cleaning at a specific point and will move outwards in a spiral motion. Then, it will return to the
starting point in a spiral motion again.
Once it finishes at the starting point, it will return to the charging base.
Smart Area mode
Once the home's map has been saved, select this mode on the desired map for the robot to
clean a specific area in zigzag motion. The robot will clean the selected area and then will
return directly to the charging base. The robot will only clean the area selected on the map,
therefore it will go to the point and return to the base without vacuuming.
Spot mode
Select this mode if you want to clean thoroughly point in the map, making the most of the
robot's maximum power. The robot will clean the selected point in an outward spiral motion
and then will return to the starting point. Then, it will return directly to the charging base when
cleaning is completed.
39