Uline H-6517 Manual De Instrucciones página 3

WARNING! To prevent a possible fire, injury to
persons or damage to the heater, adhere to
the following safety precautions:
• Disconnect all power coming to heater at main
service panel before wiring or servicing.
• All wiring procedures and connections must
be in accordance with the national and local
codes having jurisdiction and the heater must be
grounded.
• Verify the power supply voltage coming to heater
matches the ratings as shown on the heater
nameplate.
CAUTION! Energizing heater at a voltage
greater than the voltage printed on the
nameplate will damage the heater, void the
warranty and could cause a fire.
CAUTION! High temperature. Risk of fire. Keep
electrical cords, drapery, furnishings and other
combustibles at least 3' from front of heater.
Do not install heater behind doors, below
towel racks or in an area where it is subject
to being blocked by furniture, curtains or
storage materials. Hot air from the heater may
damage certain fabrics and plastics.
PAGE 3 OF 21
SAFETY
• To reduce the risk of fire, do not store or use gasoline
or other flammable vapors and liquids in the vicinity
of the heater.
• When heater is to be wall- or ceiling-mounted,
the anchoring hardware must be strong enough
to support the total weight of the heater, plus the
weight of the mounting hardware. Failure to properly
mount the heater to the building structure could
allow the heater to fall.
• The following minimum clearances must be
maintained:
• For vertical airflow, bottom of heater to floor:
6' minimum, 11' maximum
• For horizontal airflow, bottom of heater to floor:
6' minimum, 8' maximum
• Sides of heater to adjacent wall:
airflow from horizontal to 45° downward: 13";
airflow from 45° downward to straight down: 48"
• Discharge to any object: 36" minimum
• Do not use heater to dry paint or plaster. Sawdust
and drywall sanding dust will permanently damage
the heater and must be kept out of the heater.
0521 IH-6517