Care And Cleaning - LUND Interceptor Instrucciones De Instalación

Installation Steps
Use a grease pencil to mark where the holes in the hood shield align with the hood edge. Use a hammer and
center punch to mark these points in preparation for drilling. Carefully use a drill fitted with a #16 bit (.177" /
4.5mm) and a stop collar to drill a 1/8" (3mm) hole in the hood. After drilling, apply an anti corrosion agent to
#16
.177"
4.5 mm
7
Insert a screw through each hole and secure hood shield to hood. NOTE: DO NOT OVERTIGHTEN.
8
Close the hood and use an alcohol pad to clean
the locations on the hood surface indicated.
9

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Lund
and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in terms of
fit, durability, finish and ease of installation.
™
NOTE: Actual application may vary slightly from illustrations.
X4
X4
®
branded products offered by Lund International, Inc. We take the utmost pride in our products
800-241-7219 • Visit us at lundinternational.com
© 2012 Lund International, Inc. All rights reserved.
Lund and the Lund logo are trademarks of Lund International, Inc.
® ®
the hole. Repeat for remaining holes.
#16
.177"
4.5 mm
1/8"
3 mm
Remove cover from adhesive backing on the bottom
of the five (5) bump ons, and apply to the locations
10
Lund International
Page 3 of 3
CAUTION: DO NOT DRILL
THROUGH HOOD TO OPPOSITE
SIDE.
CAUTION: DO NOT PUSH SCREW
THROUGH TO THE OPPOSITE SIDE
OF THE HOOD.
cleaned in Step 9.
X5