Care And Cleaning - LUND 26410014 Instrucciones De Instalación

Installation Steps
At center bracket, insert bolt with lock and flat washer through hole in rocker panel pinch weld and and into U-nut on brack-
et. Next, install 2nd bolt with washers through bracket and into U-nut installed in Step 3. Do not fully tighten at this time.
4
At the driver side rear, align the running board bracket with the holes located in Step 1. Install (2) bolts and washers by inserting
them through the rocker panel flange and screwing them into the U-nuts. Next, install (2) more bolts and washers by inserting
them through the top holes in the bracket and screwing them into the rocker panel. Do not fully tighten at this time.
5
6
Inspection After Installation
• Inspect all bolts and nuts for proper tightness.

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
• Do not use cleaning solvents of any kind.
Congratulations!
You have purchased one of the many quality Lund
our products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product
is top quality in terms of fit, durability, finish and ease of installation.
™
NOTE: Actual application may vary slightly from illustrations.
Repeat for the bracket at the driver side front bracket.
Check boards for final position and tighten all bracket hardware
to 18-20 lb-ft. Repeat Steps 1-6 for passenger side.
®
branded products offered by Lund International, Inc. We take the utmost pride in
800-241-7219 • Visit us at lundinternational.com
© 2013 Lund International, Inc. All rights reserved.
Lund and the Lund logo are trademarks of Lund International, Inc.
® ®
Lund International
Page 3 of 3