Important; Use; Intended Use - Ingun MA Serie Manual Del Usuario

not be exceeded.
Always equip the test fixture with the correct protective conductor wiring, a protective

conductor connection and an integrated safety switch before carrying out testing work.
The test fixture must be customised so that it is safe to touch and does not permit tools with

a diameter of > 2.5 mm to come into contact with live parts.
CAUTION R
ISK OF PIERCING OR PUNCTURE INJURY
Mechanical hazard due to sharp test probes!
Maintenance work must be carried out by trained specialists only!

The installation of test probes must be performed using the designated insertion tool only!

CAUTION D
ANGER OF INJURY BY CRUSHING OR SHEARING
Risk of injury from mechanical moving parts for options with pneumatic or electrical drive sys-
tems!
Do not activate pneumatic or electrical functional units until the housing has been

completely closed!
CAUTION R
ISK OF BURN INJURIES ON HOT SURFACES
Thermal hazard due to hot inductor housing for options with electromagnets!
Use INGUN magnet control unit when operating electromagnets for long periods.


IMPORTANT

T
EST ADAPTER CONFORMING TO THE
Fully wired test adapters with drive are treated by INGUN as a machine as set out by Machin-
ery Directive 2006/42/EC and therefore delivered with CE mark. Before commissioning the
test adapter, the operator must ensure that the test system is able to meet the following
specifications:
- Emergency shut down (see Machinery Directive 2006/42/EC, Chapter 1.2.4.3. page 16)

- Avoidance of the risk of uncontrolled movement (see Machinery Directive 2006/42/EC,

Chapter 1.3.9. page 19)
- Separation of energy sources (see Machinery Directive 2006/42/EC, Chapter 1.6.3. page

23)
- Functional tests of the electrical equipment and the functions of electrical safety circuits

(see DIN EN 60204-1, Chapter 18.6. page 88)
4)

Use

4.1)

Intended use

The manual MA xxxx series test fixture is designed specifically for use in the field of industrial man-
ufacturing/testing of electronic assemblies. The test fixture is connected to an existing test system.
The electronic assemblies to be tested are connected within the test fixture and are then tested or
programmed. A replacement kit (ATS) suitable for the electronics to be tested is installed in the
test fixture. The test fixture must be operated only with original Ingun ATSs.
4.2) Foreseeable incorrect application
Operating the test fixture is not permitted if one of the following incorrect uses applies:
 Operating with incompletely mounted housing
 Operating with unapproved test voltage
 Unauthorised modification or conversion of the test fixture by the operator or the staff
 Any method of working that impairs safety
 Any method of working that goes beyond the intended test operation
23
!
M
ACHINERY
©
INGUN: Subject to technical changes without notice. E&OE.
!
!
D
IRECTIVE
English