Environmental Protection - GRAPHITE 59G812 Instrucciones De Uso

REPLACING THE CARBON BRUSHES
Worn (shorter than 5 mm), burnt or cracked motor carbon brushes should be immediately replaced. Both carbon
brushes should be always replaced at the same time.
●
Loosen the covers of the carbon brushes (
●
Remove the worn carbon brushes.
●
Remove any carbon dust using compressed air.
●
Insert new carbon brushes (brushes should easily slide into the brush holders).
●
Fasten the covers of the carbon brushes (
After the carbon brushes are replaced, switch on the tool with no load and wait for 1-2 minutes
to make the carbon brushes fit the motor commutator. Carbon brushes should be replaced by a
qualified person using original spare parts only.
All types of faults and defects should be eliminated by an authorised service of the manufacturer.
RATED DATA
Power supply voltage
Power supply frequency
Rated power
No load spindle speed:
Angle sawing range
Mitre sawing range
Outside diameter of cutting disc
Hole diameter of cutting disc
Workpiece dimensions
angle/mitre
Guide length
Laser class
Laser power
Laser wavelength
Protection class
Weight
Year of manufacture
NOISE AND VIBRATION DATA
Acoustic pressure level: Lp
A
Acoustic power level: Lw = 108,2 dB(A) K = 3 dB(A)
A
Vibration acceleration value: a
Electrically powered products should not be disposed of with household wastes, but
should be utilised in proper recycling centres. Obtain information on waste recycling
from your seller or local authorities. Used electric and electronic equipment contains
substances active in the natural environment. Unrecycled equipment constitutes a
potential risk for the environment and human health.
* The right to make changes is reserved.
8).
8).
SPECIFICATIONS
Mitre saw
Parameter
0° x 0°
45° x 0°
45° x 45°
0° x 45°
= 95,2 dB(A) K = 3 dB(A)
2
= 2,936 m/s K = 1,5 m/s
h

ENVIRONMENTAL PROTECTION

2
25
Value
230V~
50Hz
1800W
4800min -1
± 45°
0° ÷ 45°
254mm
30mm
90 x 280mm
90 x 200mm
50 x 200mm
50 x 280mm
195mm
2
< 1mW
λ = 650nm
II
16 kg
2014